Experience sharing of pipe automatic welding processing:

1.如果送絲不穩定，應立即停止，待處理后繼續焊接;

1. If the wire feeding is unstable, stop immediately and continue welding after treatment;

2.仰焊時，應將焊槍的電纜拉直，及時處理焊槍的扭曲;

2. During overhead welding, straighten the cable of the welding gun and deal with the distortion of the welding gun in time;

3.加強焊工責任教育，發現問題立即停止焊接，并及時處理。如果不確定，就需要咨詢有經驗的人;

3. Strengthen the responsibility education of welders, stop welding immediately if problems are found and deal with them in time. If you are not sure, you need to consult an experienced person;

4.確保接地線接觸良好;

4. Ensure good contact of grounding wire;

5.焊接防風棚，采取防風措施;

5. Welding windproof shed and taking windproof measures;

6.確保發電機網絡電壓在正常范圍內;

6. Ensure that the generator network voltage is within the normal range;

7.不要堵塞焊機的風管;

7. Do not block the air duct of the welding machine;

8.隨時檢查保護氣路和煤氣表是否漏氣;

8. Check whether the protective gas circuit and gas meter leak at any time;

9.每天焊接后，務必清理焊接小車和送絲機上的飛濺物、鐵屑和灰塵;

9. After welding every day, be sure to clean the spatter, scrap iron and dust on the welding trolley and wire feeder;

10.每個防風棚應盡可能配備一臺空氣壓縮機，以清理焊接設備和防風棚內的鐵屑和灰塵，為焊工提供良好的工作環境;

10. Each windproof shed shall be equipped with an air compressor as far as possible to clean the iron filings and dust in the welding equipment and windproof shed and provide a good working environment for welders;

11.在轉移到下一個焊接接頭之前，一定要切斷焊機電源，然后才能移動;

11. Before transferring to the next welding joint, the power supply of the welding machine must be cut off before moving;

12.未經培訓的焊工不得工作;

12. Untrained welders shall not work;

13.嚴禁非正式人員打開機殼進行焊接設備維修。

13. It is strictly forbidden for informal personnel to open the casing for welding equipment maintenance.

本文的精彩內容由山東數控焊接設備為您提供，本網站還有很多的精彩內容，更多的內容您可以點擊進入：http://hk809.com我們有專門的客服為您解答問題

The wonderful content of this article is provided by Shandong CNC welding equipment. There are many wonderful contents on this website. You can click to enter more contents: http://hk809.com We have special customer service to answer your questions